Separate names with a comma.
The main reason my Rc tester is certified.
If it is a easy to read script it is ok, as long as it can be decifered
a grade 8 bolt will work
Then do not scrimp on a grinder, buy once, cry once
Also something to consider, if you find knifemaking is not for you, you can sell the grinder for almost full cost.
Etch mark while in the white, mask mark with a piece of stick on vinyl, etch, peel off vinyl and use a qtip with a little ferris on it to just...
Several possibilities, what steel?
Yes, clamp on one end, put a flat washer under the other end and clamp in the middle just passed straight.Temper again
Spring is warped, try to straighten by clamping to a flat bar and retemper.
Or make another spring.
80 through 2k
120 and 220 are ceramic psa from Pops, the rest are 9" paper stuck on with spray
I have the Neilson system w/6 discs, one...
My shelf is held on by 2 1/8" brass pins peened in place, grind the glass to length.
No, you want the pin soft so it will pin easily and hide.
On some slipjoints I will thin bone to
I have one on my pocket that the bone is only .040 where it meets the bolsters.
Just tested a piece, Rc 16
Alpha knife supply 9is the go to for small steel orders. Shippingis very reasonable
I do the same.
Or just use a thin coat of satinite.
I use 1/8" micarta for fixed blades. And 3/32 A2 for folders
Mine arrived today, thanks Jason.