Separate names with a comma.
I had something similar years ago and the biggest problem I had was the ceramic rods loaded up and there was no easy way to clean them
For a given steel, CPM or any other powdered version should be tougher, all else being equal. Some steels come in non CPM versions while others...
I would say it is like asking if a marker can replace a pen. sure it can bit try and write someone a letter and you will use up a lot more paper....
most oil free compressors use Teflon and graphite impregnated parts to seal with. I would not try and spray any lubricant in it. I've done that...
I would make sure you have some way of checking the oil level. it may also be a good idea to change out whatever was in there for some mineral oil...
Be aware that many belts are directional, so also remember to flip the belt too if needed
Nail polish remover's active ingredient is acetone (while at least the good stuff is), so either that or just straight acetone. There is not a...
Thermocouple locations like that are often times used for opening up more floor space. Place it in the middle lower portion between knives will...
Haha, yeah, I didn't see that
What about peters heat treat? There equipment should be big enough and they should also be familiar with AEB-L
For a non stainless, I'm voting for 5160 as it is cheap, easy to heat treat and works quite well for what it is Semi stainless, CPM 3V. Great...
The grit will eventually be lost or work it's way deeper into the leather. Periodic application of the compound will be needed. I like to add a...
Yep. Some will apply a little mineral oil to help thin the compound but it is not necessary. Just rub the compound over the leather. A crosshatch...
Rub it on
If it's turning yellow or darkening over time after curing then its likely from UV degradation or too much catalyst. All "epoxy" will degrade from...
A lanyard at the end of the handle can be dangerous as mentioned above but one near the top of the handle or near the bolster can help with...
I would not worry about it. Rex45 is a high speed steel with lots of cobalt in it. This makes it vary tolerant of high heat
No problem. We all make mistakes every now and then
??? Are you sure about that? For a three phase motor. Sometimes but rarely for a three phase Y connection you can add a ground or a neutral to the...
There is no way burning iron will produce more energy than it takes to refine the rust. Then add in the original refining process and it will end...
