Separate names with a comma.
Lionsteel responded in comments. And I'll never buy another one again due to the responses they gave. Really bad responses that tell me they do...
Ken onion on what a midtech is
Just look at the pictures.
It's far from an exact copy. There are pictures embedded in the thread showing its not.
Just read someone had one at 57hrc https://www.instagram.com/p/ByqfedqnPWL/?igshid=s980oe418l51
inthepocket mentioned Vinny had one around 57...
Iirc Peter's heat treats them to 60-61 and he's generally pretty good with his batch heat treatment. Of course there are always a few issues now...
They ain't. These hipsters really don't know any better. This isn't the old Benchmade we once knew. You should hear the bladehq bladeshow vid they...
The info was true... Across the board 58hrc is the average m390. That was the point I was trying to make. I was off a digit but the fact still...
Stop crying over a single point. And the actual facts I was talking about went out the window cause you were too fixated on the one digit off.
If a manufacturer can't heat treat a superior steel to supersed its base s30v then just don't use that steel. They doing it cause it's popular...
Probably avoid aliexpress all together.
Ask spyderco for washers
What about Lazer or edm sharpening? :)
Don't get them until you need them. Else your just wasting the money. They don't wear out for a very long while. Most likely just get some for...
Would it look any better without the holes? No. They took the prototype and neutered it.
Makes a bailsong and it breaks a few days later.
Nother vid of one from knife nuts Podcast
More pics I found on Instagram from bladeshow 2019