- Joined
- Dec 18, 2019
- Messages
- 2
Hi I'm new to the forum but have been messing around with making knives for the past few years. I finally bit the bullet and bought a good grinder and would like to try my hand at straight razors.
I'm all set up for it but jentz, where I prefer to shop, doesn't carry 1095 in 1/4" but instead carries 1075. Just wonder if it will hold that kind of edge.
I don't want to spend the money on 01 until I've made a few and know I'm not going to be scrapping them.
Thanks
I'm all set up for it but jentz, where I prefer to shop, doesn't carry 1095 in 1/4" but instead carries 1075. Just wonder if it will hold that kind of edge.
I don't want to spend the money on 01 until I've made a few and know I'm not going to be scrapping them.
Thanks