1st Talonite knife

Bill Siegle

Bill Siegle

Knifemaker / Craftsman / Service Provider
Joined
Oct 3, 2000
Messages
6,798
1st off many thanks to Rob Simonich for answering my questions on how to play with this stuff. I finally broke down and decided to try this stuff out. I can't wait to see how it performs. The blade is 1/8in thick and the handle slabs are green & black G10. I don't know if I'm willing to go into production with Talonite but I have to say it was easier to work than I thought it'd be. Let me know what you folks think.

Bill
 
thank you for the comments. It was fun playing with the Talonite. I've been wanting to try it since I 1st heard about it. I mean really ....by most accounts it's Miracle material and so far it may just be. Easy to work(reletively),stainproof,and holds a descent edge. About the only negative is material cost. Thanks for checking out the article too:)

Bill
 
You must log in or register to reply here.
Back
Top