Kizer Cutlery Ki412A3 BROKEN POCKET CLIP!!!

B

BladeManiac10913

Joined
Jun 8, 2014
Messages
101
Recently while i was getting out of a friends car, my kzier's clip got snagged on a hole in the leather seat, and it just snapped!!! It is a fully ti clip, and while i know a lot of force was put on it from me getting out, does anyone know if i can get it replaced? And if anyone has ever taken the clip off and/or put it back on, what tools did you use, because Kizers knife (at least this one) does not have a torx compatible pivot screw thanks!!!

(This is a pic prior to the accident...)
 
Just contact kizer, they'll send you a new one. As far as the pivot, an Allen wrench should fit, if not use a flat head.
 
Shouldn't have to take the pivot apart to get the clip off, it should have it's own Torx screw I believe, unless that model is different than all my Kizers.

I'm sure they'll take care of you if you email them.

Some Kizer pivots fit a large HEX head, most of the ones I have are round in the center. A wide thin blade screwdriver works fine if you are slow and careful. Yours looks like it would take a HEX in the center of the spokes.
 
Hi, Blademaniac10913:

Please PM me or email me.

Thanks.

Kizer.
 
^I'm so impressed by your presence on the forum, such great customer service!
 
I sent an email concerning a problem with mine too, but no response. It's not a problem with the clip, but the very uneven grind when comparing both sides of the blade. It's so uneven that the spine looks crooked.
 
Hi, gooeytek:

I sent you a PM. I apologize for the lack of answer on the email, I'll go back and check the filter to see if that caught it.

Thanks.

Kizer.
 
You must log in or register to reply here.
Back
Top