Looking for a Molle compatible M9 Bayonet sheath

We're going to take a wild guess that you also asked on Facebook. We'll see if there's anything like that around the building.
 
After checking around, we have not made a MOLLE compatible M9 sheath. That doesn't mean one doesn't exist, but sadly, we wouldn't have one we can provide for you. Some of the other guys on this forum might have thoughts on where to find one.
 
OntarioKnifeCompany said:
We're going to take a wild guess that you also asked on Facebook. We'll see if there's anything like that around the building.
Click to expand...


Yea I did lol. I didnt see many replies on Facebook from u guys so I assumed here would of worked better. Thanks once again for answering my questions I love your knives
 
Depending on your specific needs, a Spec-Ops Combat Master might work.

Check the knife dimensions against the sheath dimensions to make sure the knife will fit.

The two upper belt loops should be able to secured to the Molle webbing. And there is a loop at the bottom that can either be tied off or lashed. Or you can just make a loop with P-cord to go over the sheath near the bottom to keep it from flopping around. Slide the sheath down through the loop and slip the two belt loops through the molle webbing snap 'em up and your good to go.
 
Ontario did make a molle sheath that will fit the m9.

It was for the now discontinued M10 bayonet.This was basically a m9 with a 1095 carbon blade.

These bayonets and sheaths may be hard to find now.

All I did is to remove the original webbing and made a molle compatible webbing like the m10 sheath.

LanCay also made a molle version,but it was only a trial piece i think.
 
Check around for a " MOLLE II K-Bar Adapter". They're around $2.50 and may do what you want. They essentially convert a belt mounted item to MOLLE mountable. Good luck.
 
You must log in or register to reply here.
Back
Top