Recently Finished

Discussion in 'Gollik Knives' started by gollik, May 9, 2018.

Thread Status:
Not open for further replies.
  1. SixtyLion

    SixtyLion

    110
    May 6, 2010
    Hello Jakub,

    Hopefully you and your family are healthy and safe! When you will have some time could you tell me, have you ever made a Kukri knife? I was wondering how much would it cost to make a custom kukri, full-tang thick Elmax, full flat gring blade 7 1/2 - 8 inches, and 5.5-6 inch flared handle with G10 scales. Thank you very much!!!
     
  2. gollik

    gollik KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    331
    Mar 8, 2012
    0.17" Sleipner tool steel , 5" blade, DLC coating, micarta handle, G10 liners.

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    knivesnknucks likes this.
  3. gollik

    gollik KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    331
    Mar 8, 2012
    0.19" Elmax, 4" blade, DLC coating, G10 handle.

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    Penang and knivesnknucks like this.
  4. gollik

    gollik KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    331
    Mar 8, 2012
    1/4"Sleipner tool steel, 7" blade, micarta handle.

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    David Lennon likes this.
  5. gollik

    gollik KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    331
    Mar 8, 2012
    1/4"Sleipner tool steel, 6 1/2" blade, micarta handle.

    [​IMG]
    [​IMG]
    [​IMG]
     
  6. gollik

    gollik KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    331
    Mar 8, 2012
    0.15" N690, 4.5" blade, micarta handle.

    [​IMG]
    [​IMG]
    [​IMG]
     
  7. gollik

    gollik KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    331
    Mar 8, 2012
    0.25" Sleipner, 7" blade, DLC coating, micarta handle, G10 liners.

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
Thread Status:
Not open for further replies.

Share This Page