- Joined
- Jan 9, 2011
- Messages
- 16,030
.315" S7 Steel Prybars are ready!
I put a ton of work into these but they are made to use and use hard! The finish is meant to wear nicely and these are tough enough to take just about anything you can throw at them. S7 is commonly used for jackhammer blades for a good reason.
These are heat treated for maximum toughness at a decent hardness... which happens to be around 58 RC with S7 so these are tough and wear resistant.
Dimensions
~4.5" long
~1/2" tall
~.315" thick
Each one is a bit different... I had a lot of fun making these and hope they get lots of use!
$75 shipped at www.fairlyknives.com (international shipping is extra) One left!
Just click on the pics to enlarge them, Thanks for checking out my work!
I put a ton of work into these but they are made to use and use hard! The finish is meant to wear nicely and these are tough enough to take just about anything you can throw at them. S7 is commonly used for jackhammer blades for a good reason.
These are heat treated for maximum toughness at a decent hardness... which happens to be around 58 RC with S7 so these are tough and wear resistant.
Dimensions
~4.5" long
~1/2" tall
~.315" thick
Each one is a bit different... I had a lot of fun making these and hope they get lots of use!
$75 shipped at www.fairlyknives.com (international shipping is extra) One left!
Just click on the pics to enlarge them, Thanks for checking out my work!
Last edited: