Serpentine Pattern

[PWork]

Anyone know of any single blade serpentines currently being produced? I'd like to find something 3 1/2" closed with a 2 1/2" blade. Round bolsters are MUCH prefered over squared ones, and the tang MUST NOT protrude above the handles when closed. How about custom makers? Any out there producing something like this on a regular basis?
Any help greatly appreciated.

Paul

 

[Bastid]

Check out Richard Rogers. He has been making qute a few single blade serpentines in the last few years. At the same time all of the big names do them. Joe Kious did a two bladed Dr knife for me based on an serp. Ulster pattern from the '20's last year.

 

[El Lobo]

PWork,

A little smaller than you mentioned, and I'm not sure if the run up on the tang is completely sunk when closed....I guess if it appealed to you otherwise, you could call A.G. and ask.....

http://www.agrussell.com/knives/pro...ker/bker_gold_lip_pearl_gentlemans_knife.html

Just trying to help.

Bill

 

[PWork]

Bastid, Richard Rogers is on my short list. I've only seen pics of his knives, but I have long admired them.

El Lobo, That little Boker is nice, but wayyyyyyyy too small. I don't like damascus or pearl either ( I think I'm the only one ).

Thanks for the suggestions guys.

Paul

 

[OTguy]

Case made a run of some or their popular frame patterns with single blades a few years ago. Last time I checked some were still available at BVB Ranch's website, you might also check SMKW to see if they still have any.