Spyderco Withdrawn. Spyderco Dragonfly 2 Sprint run in ZDP-189 British Green (New In-Box)

AmericanEDC

Gold Member
Feedback: +22 / =0 / -0
Joined
Jun 5, 2013
Messages
448
$withdrawn
$withdrawn 48 contiguous $4.00 more for Alaska and Hawaii

Paypal FF preferred (no notes), I accept Zelle. PP G&S is fine but be sure to add the fee yourself. First "I'll take it" here followed by a PM gets it; for members that can't PM please leave your email address. No trades at this time please. I reserve the right to sell to whomever regardless of time stamps (paid member, no feedback, poor feedback, etc.)

Loved my first Dragonfly 2 so much upon arrival that l immediately bought a second as the screenshot shows. By the time these ran out they were selling for upwards of $200.00. I think that's a bit much for this smaller EDC knife so I've priced a much more reasonable number for anyone trying to flesh out their collection.

I will never carry this second one, so want to pass along as I'm reducing my non-users as I age out here. I see some hairline marks on the one side. I'm not sure what that is, and impossible to see in normal light. I've done my best to capture it under bright LED's. And I took additional photos after seeing it upon posting to photo hosting site. At normal viewing distance and in normal light it really cannot be seen.

If you feel a more appropriate price is warranted, make an offer and I'll consider based on interest.

joHRoLQh.jpg

evEmUKgh.jpg

DwwXrfVh.jpg

xSZsGPPh.jpg

IfhiOuJh.jpg

54LAYzth.jpg

6HKOLUSh.jpg

SK7GE1wh.jpg

6IyHoxZh.jpg

hAnCWffh.jpg

VtDzc4Ph.jpg

CJN57rih.jpg
 
Last edited:
Hey there, don't suppose you know the HRC they treated the zdp to? I know Spyderco always does a good job, but just curious. Thanks!
 
Hey there, don't suppose you know the HRC they treated the zdp to? I know Spyderco always does a good job, but just curious. Thanks!
This forum thread at Spyderco involves Sal himself in discussing that Hitachi requires use of their own authorized heat treaters. I do not believe there is any way to know beyond the Hitachi required specs they hold the heat treaters to. My guess is 67-68 HRC is most likely though it can go to 70. I believe Hitachi recommends 66-68 HRC.


“We can purchase any steel that Hitachi makes except ZDP because of their heat treat requirements. So all of our ZDP models are made in Japan by makers that we know use Hitchi's heat treaters.”
 
Back
Top