- Joined
- Feb 11, 2003
- Messages
- 1,628
Just wanted to give you guys/gals a heads up on what I am working on.
Just got done ordering a full sheath of CPM 3V in 1/4" to start a second run of Dingo's. These are going to be fun! I have been working with Larry Davidson and this run will have some KICK ASS 3D milled G-10 scales. REALLY excited about this!
I also ordered a sheet of 3/16" CPM 3V to get a second K9 Knife into production. I am hoping to get 3D handles on these also. I can't wait to get a few prototype blades back from heat treatment. This is going to be one hard working blade!
In the future I hope to offer all K9 knives in CPM 3V AND CPM 154 for a bit more corrosion resistance. As of now CPM 154 is unavailable though... soon!
THANKS for all your support!
Tom Krein
K9 Knives
Just got done ordering a full sheath of CPM 3V in 1/4" to start a second run of Dingo's. These are going to be fun! I have been working with Larry Davidson and this run will have some KICK ASS 3D milled G-10 scales. REALLY excited about this!
I also ordered a sheet of 3/16" CPM 3V to get a second K9 Knife into production. I am hoping to get 3D handles on these also. I can't wait to get a few prototype blades back from heat treatment. This is going to be one hard working blade!
In the future I hope to offer all K9 knives in CPM 3V AND CPM 154 for a bit more corrosion resistance. As of now CPM 154 is unavailable though... soon!
THANKS for all your support!
Tom Krein
K9 Knives