1. Click here to enter the drawing for your chance to win an Ontario Knives Spec Plus SP8 Machete Survival Knife & Ka-Bar Dozier Folding Hunter, , Bladeforums.com swag or memberships!

    Be sure to read the rules before entering, then help us decide next week's giveaway by hitting the poll in that thread! Entries close at midnight, Saturday Sept 7!

    Once the entries close, we'll live stream the drawing on Sunday, Sept 8 at 5PM Eastern. Tune in to our YouTube channel TheRealBladeForums for a chance to win bonus prizes!

    Questions? Comments? Post in the discussion thread here

>><< Example waterjet machined Heat Treat fixture

Discussion in 'Waterjet by H2Oknife' started by H2Oknife, Mar 10, 2013.

  1. H2Oknife

    H2Oknife Waterjet Service Provider Moderator Knifemaker / Craftsman / Service Provider

    428
    Jan 23, 2010
    Had quite a contrast again this week, we made a Heat Treat fixture with 3" 304 SS then Slip Joint Shield inlays from .060" thick 410 SS
    Note the squareness of the edge! Contrary to tribal knowledge....

    ISO view.jpg 1-2_3.jpg ShieldsampleA.jpg
     

Share This Page