- Joined
- Jan 15, 2002
- Messages
- 430
Hi guys. Its been awhile. I've been busy expanding my variety. This is my first full tang knife. I usually only do trad Japanese stuff. First time I ever made a handle too! 
Thanks Ron. Anyways, here are some pics. If you like lemme know.
SPECS: CPMS90V, HRC59 (I do all my own heat treating) Fully Convex blade/edge. Ground from 1/8" stock. 180 grit, plus fine scotch-brite finish. Blade tapers. Spine beveled. Flat, full tang. Front, "reverse" bevel is sharpened full convex as well. Blade is 4", handle is 4.5". Blade width max 7/8". Handle thickness approx 3/4". Black linen micarta. Single mosaic pin. Copper thong hole tube.
MORE PICS AVAILABLE ON MY SITE, UNDER "CURRENT PROJECTS".
Thanks Ron. Anyways, here are some pics. If you like lemme know.SPECS: CPMS90V, HRC59 (I do all my own heat treating) Fully Convex blade/edge. Ground from 1/8" stock. 180 grit, plus fine scotch-brite finish. Blade tapers. Spine beveled. Flat, full tang. Front, "reverse" bevel is sharpened full convex as well. Blade is 4", handle is 4.5". Blade width max 7/8". Handle thickness approx 3/4". Black linen micarta. Single mosaic pin. Copper thong hole tube.
MORE PICS AVAILABLE ON MY SITE, UNDER "CURRENT PROJECTS".
