Been a while since I've put up pictures of my EDCs. Been carrying this Tiger for 3 months now after installing the po-boy parts from a bundled purchase. Fun fact, I was fortunate to buy that signed Tiger in person at Emerson's LA show room back in 2015. It is a cherished piece. The Upscale CQC-7 was a recent purchase where the original owner had the blade zero ground at REK. It was used and had a small chip on the forward edge. Since getting it, I've re-sharpened the zero grind and also re-polished the flats. Still need to grind a little more on the forward bevel and decide how polished I want to make everything. Right now the flats are at 400 grit while the bevels are at 1000 grit. Indoor lighting sucks.
I’m trying to figure out what is causing it on mine.
Do you find that with a little muscle you can get some up and down play on your cqc7 flipper? I found that I was able to do that on a few of them that I have tried.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.